LEMON Manuals: Even more car manuals for everyone
Home >> Honda >> 2005 >> CR-V EX, Standard >> Repair and Diagnosis >> Engine Performance >> System >> Fuel Supply System >> Fuel Pulsation Damper Replacement

Fuel Pulsation Damper Replacement

  1. Relieve the fuel pressure (see FUEL PRESSURE RELIEVING  ).
  2. Remove the engine cover.
  3. Remove the fuel rail mounting nuts from the fuel rail.
  4. Remove the ground cable (G101).
  5. Raise the fuel rail.
  6. Place a wrench (A) on the fuel rail (B).
    Fig 1: Placing Wrench On Fuel Rail And Fuel Pulsation Damper
    G03674259Courtesy of AMERICAN HONDA MOTOR CO., INC.
  7. Place a wrench (C) on the fuel pulsation damper (D).
  8. Remove the pulsation damper.
  9. Install the fuel pulsation damper in the reverse order of removal with the new washers.
    NOTE:
    • Replace all washers whenever the fuel pulsation damper is loosened or removed.
    • If the drain hole (A) of the fuel pulsation damper cover does not face bottom, reinstall it as shown.
    Fig 2: Installing Fuel Pulsation Damper In Reverse Order Of Removal With New Washers
    G03674260Courtesy of AMERICAN HONDA MOTOR CO., INC.
scientia non olet · About LEMON Manuals