LEMON Manuals: Even more car manuals for everyone
Home >> Honda >> 2004 >> Pilot EX >> Repair and Diagnosis >> External Pages >> Different car >> Section 2 (Air Bag Restraint Systems) >> Diagnostics >> Erasing Diagnostic Trouble Code Memory >> Erasing DTC Memory Using SCS Service Connector

Erasing DTC Memory Using SCS Service Connector

WARNING: This page is about a different car, the 2003 Honda Pilot. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn ignition switch to OFF position. Connect SCS Service Connector (07PAZ-0010100) to Memory Erase Signal (MES) connector. See Fig 1.
  2. Turn ignition switch to ON position. AIR BAG warning light will come on for about 6 seconds then go off.
  3. Disconnect SCS service connector from MES connector within 4 seconds after AIR BAG warning light goes off. AIR BAG warning light will come on again.
  4. Reconnect SCS service connector to MES connector within 4 seconds after AIR BAG warning light comes on. AIR BAG warning light will go off.
  5. Disconnect SCS service connector from MES connector within 4 seconds. AIR BAG warning light will indicate that memory is erased by blinking 2 times. Turn ignition switch to OFF position and wait 10 seconds. DTC's are erased if AIR BAG warning light comes on for 6 seconds and then goes out.
Fig 1: Locating Memory Erase Signal (MES) Connector
G99I24453Courtesy of AMERICAN HONDA MOTOR CO., INC.
scientia non olet · About LEMON Manuals