LEMON Manuals: Even more car manuals for everyone
Home >> Honda >> 2003 >> Odyssey LX >> Repair and Diagnosis >> Engine Performance >> System >> Fuel & Emissions Systems >> How to Set Readiness Codes >> Evaporative Emission (EVAP) Control System Monitor and Readiness Codes >> Procedure

Evaporative Emission (EVAP) Control System Monitor and Readiness Codes: Procedure

  1. Connect the scan tool to the vehicle's data link connector (DLC), and bring up the tool's generic OBD II mode.
  2. Start the engine.
  3. Test-drive the vehicle under stop-and-go conditions with short periods of steady cruise. After about 2.5 miles (1.6 km), the readiness code should switch from incomplete to complete.
  4. If the readiness code is still set to incomplete, check for a temporary DTC. If there is no DTC, one or more of the enable criteria were probably not met; repeat the procedure.
scientia non olet · About LEMON Manuals