LEMON Manuals: Even more car manuals for everyone
Home >> Honda >> 2003 >> Odyssey EX >> Repair and Diagnosis >> Body & Frame >> Door Locks >> Power Sliding Door System >> Component Tests >> Slide Motor Test >> Right Side

Right Side

  1. Remove right rear interior side trim panel. Disconnect sliding door motor 2-pin harness connector. Using fused jumper wires, connect battery voltage to sliding door motor harness connector terminal No. 2 (Blue wire) and ground sliding door motor harness connector terminal No. 1 (Black wire). See Fig 1. Sliding door should open. Go to next step.
  2. Using fused jumper wires, connect battery voltage to sliding door motor harness connector terminal No. 1 (Black wire) and ground sliding door motor harness connector terminal No. 2 (Blue wire). Sliding door should close. If sliding door does not operate as specified, replace sliding door motor and retest system. See SLIDING DOOR MOTOR UNIT  under REMOVAL & INSTALLATION.
Fig 1: Identifying Power Sliding Door Motor Terminals
G99G52411Courtesy of AMERICAN HONDA MOTOR CO., INC.
scientia non olet · About LEMON Manuals