LEMON Manuals: Even more car manuals for everyone
Home >> Honda >> 2003 >> CR-V EX, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 4 (Fuel & Emissions Systems) >> How to Set Readiness Codes >> EGR Monitor and Readiness Code >> Procedure

EGR Monitor and Readiness Code: Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Honda Odyssey, 2003 Honda Odyssey, 2002 Honda Odyssey, 2001 Honda Odyssey, and 2000 Honda Odyssey. However, it is still accessible from the selected car via links, so may be relevant.
  1. Connect the scan tool to the vehicle's data link connector (DLC), and bring up the tool's generic OBD II mode.
  2. Start the engine
  3. Drive at a steady speed with the transmission in D position, 50 62 mph (80-100 km/h) or above for more than 10 seconds.
  4. With the transmission in D position, decelerate from 62 mph (100 km/h) or above by completely releasing the throttle for at least 5 seconds If the engine is stopped during this procedure, go to step  3 and do the procedure again.
  5. If the readiness code is still set to incomplete, check for a temporary DTC If there is no DTC, the enable criteria was probably not met, repeat the procedure.
scientia non olet · About LEMON Manuals