Clearing Abs DTCS (HSN 1102-11)

Publication date: 2002-11-01
Reference number: HSN 1102-11

CLEARING ABS DTCS

TECHNICAL SERVICE BULLETIN

Reference Number(s): HSN 1102-11, Date of Issue: November, 2002

HONDA:	All '96 and later models with ABS
CATEGORY:	Honda Service News
APPLIES TO:	All '96 and later models with ABS

SERVICE INFORMATION

NOTE: This article applies to '96 and later models with ABS.

When some ABS-equipped vehicles are run with the wheels off the ground, the ABS control unit can set a wheel sensor DTC(s) and turn on the ABS indicator. To turn off the indicator, do this:

Connect the PGM Tester to the 16P data link connector.
Clear any set DTC(s).
Disconnect the PGM Tester.
Test-drive the vehicle above 7 mph.

When the ABS control unit gets a normal vehicle speed input from all four wheels, it completes the ABS DTC clearing procedure and turns off the ABS indicator.