LEMON Manuals: Even more car manuals for everyone
Home >> Honda >> 2002 >> Insight Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 29 (Doors) >> Front Door Panel Removal/Installation

Front Door Panel Removal/Installation

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Honda Odyssey, 2003 Honda Odyssey, 2002 Honda Odyssey, 2001 Honda Odyssey, and 2000 Honda Odyssey. However, it is still accessible from the selected car via links, so may be relevant.

Special Tools Required 

Trim pad remover, Snap-on A177A, or equivalent, commercially available.

  1. Remove the mirror mount cover, power mirror (see step 2 on POWER MIRROR REPLACEMENT ), manual mirror (see step 2 on MANUAL MIRROR REPLACEMENT ). Take care not to scratch the door panel.
  2. Remove the inner handle (A). Take care not to scratch the door panel.
    • 1  Pry out the cap (B), and remove the screw.
    • 2  Pull the inner handle forward and out half-way.
    • 3  Disconnect the inner handle rod (C) and power door lock switch connector (D) (for some models).
    Fig 1: Removing Inner Handle
    G01512504Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Detach the clips and hooks (A), then remove the speaker grille (B). Remove the screws.
    Fig 2: Detaching Clips & Hooks
    G01512505Courtesy of AMERICAN HONDA MOTOR CO., INC.
  4. Remove the pull pocket panel (A). Take care not to scratch the door panel.
    • 1  Pry out the cap (B), and remove the screw.
    • 2  Release the hook (C), and disconnect the power window switch connectors (D).
    Fig 3: Removing Pull Pocket Panel (Driver's)
    G01512506Courtesy of AMERICAN HONDA MOTOR CO., INC.
  5. Release the clips that hold the door panel (A) with a commercially available trim pad remover (B), then remove the door panel by pulling it upward. Disconnect the speaker connector (C). For '02-04 models: If equipped with a seat heater, disconnect the seat heater switch subharness connector (D).

    Remove the door panel with as little bending as possible to avoid creasing or breaking it.

    Fig 4: Releasing Clips Holding Door Panel
    G01512507Courtesy of AMERICAN HONDA MOTOR CO., INC.
  6. Install the door panel in the reverse order of removal, and note these items:
    • Replace any damaged clips.
    • Push the clips into place securely.
    • Make sure the connectors are plugged in properly, and the inner handle rod is connected properly.
    • For '03-04 models: Reset the power window control unit (see RESETTING THE POWER WINDOW CONTROL UNIT '03-04 ).
    • Check the window and power door lock operations.
    • For '02-04 models: If equipped with a seat heaters, check for proper operation.
scientia non olet · About LEMON Manuals