LEMON Manuals: Even more car manuals for everyone
Home >> Honda >> 2002 >> Insight Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 100 (Keyless/Power Door Locks/Security System) >> Door Key Cylinder Switch Test

Door Key Cylinder Switch Test

WARNING: This page is about a different car, the 2006 Honda Odyssey and 2005 Honda Odyssey. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the driver's door panel (see FRONT DOOR PANEL REMOVAL/INSTALLATION ).
  2. Disconnect the 3P connector from the key cylinder switch.
    Fig 1: Disconnecting 3P Connector From Key Cylinder Switch
    G03706656Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Check for continuity between the terminals.
    • There should be continuity between the No. 2 and No. 3 terminals when the door key cylinder switch is in LOCK position. (Except VAN and LX models)
    • There should be no continuity between the No. 2 and No. 3 terminals when the door key cylinder switch is in the neutral or UNLOCK position. (Except VAN and LX models)
    • There should be continuity between the No. 1 and No. 2 terminals when the door key cylinder switch is in UNLOCK position.
    • There should be no continuity between the No. 1 and No. 2 terminals when the door key cylinder switch is in the neutral or LOCK position.
  4. If the continuity is not as specified, replace the door key cylinder assembly (see FRONT DOOR OUTER HANDLE REPLACEMENT ).
scientia non olet · About LEMON Manuals