LEMON Manuals: Even more car manuals for everyone
Home >> Honda >> 2002 >> Insight Automatic CVT >> Repair and Diagnosis >> External Pages >> Different car >> Section 31 (Interior Trim) >> Dashboard >> Driver's Switch Panel Removal/Installation

Driver's Switch Panel Removal/Installation

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Honda Odyssey, 2003 Honda Odyssey, 2002 Honda Odyssey, 2001 Honda Odyssey, and 2000 Honda Odyssey. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
  • When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
  • Take care not to scratch the dashboard and related parts.
  1. Gently pull out on the driver's switch panel (A) to release the right clips (B), then detach the remaining clips (C). If equipped, disconnect the cruise control main switch connector (D), TCS switch connector (E), power mirror switch connector (F) and power sliding door switch connector (G), then remove the panel.
    Fig 1: Gently Pulling Out Driver's Switch Panel
    G01512652Courtesy of AMERICAN HONDA MOTOR CO., INC.
  2. Install the panel in the reverse order of removal, and note these items:
    • Make sure each connector is plugged in properly (if equipped).
    • Push the clips into place securely.
scientia non olet · About LEMON Manuals