LEMON Manuals: Even more car manuals for everyone
Home >> Honda >> 2001 >> Prelude Base, Standard >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Basic Diagnostic Procedures >> Fuel Systems >> Fuel Pump Operation >> Checking Fuel Pump Operation (Without Scan Tool) - Accord

Checking Fuel Pump Operation (Without Scan Tool) - Accord

  1. Turn ignition off. Remove trunk floor. Remove fuel pump access panel. Turn ignition off and disconnect fuel pump 5-pin electrical connector. Locate PGM-FI main relay. See PGM-FI MAIN RELAY LOCATION  table. Using a jumper wire, connect PGM-FI main relay terminals No. 4 (Black/Yellow wire) and No. 5 (Red/White wire) together. See WIRING DIAGRAMS article. Turn ignition on.
  2. Using DVOM, measure voltage between body ground and fuel pump 5-pin electrical connector terminal No. 5 (Black/Yellow wire). If battery voltage is available, check fuel pump ground circuit. If ground circuit is okay, replace fuel pump. If battery voltage is not available, check wiring harness between PGM-FI relay and fuel pump harness connector.
scientia non olet · About LEMON Manuals