LEMON Manuals: Even more car manuals for everyone
Home >> Honda >> 2000 >> Insight >> Repair and Diagnosis >> External Pages >> Different car >> Section 2 (Wheel Alignment Specifications & Adjustment Procedures) >> Wheel Alignment Procedures >> Toe-In Adjustment >> Civic & CR-V

Civic & CR-V

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2000 Honda Prelude, 2000 Honda Odyssey, 2000 Honda Civic, 2000 Honda CR-V, and 2000 Honda Accord. However, it is still accessible from the selected car via links, so may be relevant.
  1. Secure steering wheel in straight-ahead position. Measure front wheel toe-in. See WHEEL ALIGNMENT SPECIFICATIONS  . If adjustment is needed, loosen tie rod lock nuts. Turn both tie rods equally in the same direction until front wheels are in straight-ahead position and toe-in reading is correct. Tighten tie rod lock nuts. Reposition tie rod boots if twisted.
  2. Ensure parking brake is released. Check rear wheel toe-in. If adjustment is needed, hold adjusting bolt on rear compensator arm and loosen lock nut. See Fig 1 . Adjust rear toe-in by sliding rear control arm until rear toe-in is correct. Install NEW lock nut, and tighten it while holding adjusting bolt.
Fig 1: Adjusting Rear Toe-In (Civic & CR-V)
G90E05957Courtesy of AMERICAN HONDA MOTOR CO., INC.
scientia non olet · About LEMON Manuals