LEMON Manuals: Even more car manuals for everyone
Home >> Honda >> 2000 >> Insight >> Repair and Diagnosis >> External Pages >> Different car >> Section 2 (Wheel Alignment Specifications & Adjustment Procedures) >> Wheel Alignment Procedures >> Caster Adjustment >> Prelude With ATTS

Prelude With ATTS

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2000 Honda Prelude, 2000 Honda Odyssey, 2000 Honda Civic, 2000 Honda CR-V, and 2000 Honda Accord. However, it is still accessible from the selected car via links, so may be relevant.
  1. If caster needs adjustment, raise front of vehicle and support it using safety stands. Remove radius rod nut and radius rod bolt from steering knuckle and frame.
  2. Remove radius rod and install appropriate length radius rod needed to adjust caster. If excessive gap between measured angle and specification exists, check for bent sub-frame or steering knuckle. Radius rod is available in 3 sizes and is identified by color and specific marking, located at center of radius rod.
  3. A .098" (2.5 mm) radius rod is identified by a plus mark (+) and is Blue. A standard radius rod is identified by a punch mark () and is Orange. A -098" (-2.5 mm) radius rod is identified by a minus mark (-) and is White. Use appropriate rod to adjust caster to specification.
scientia non olet · About LEMON Manuals