LEMON Manuals: Even more car manuals for everyone
Home >> Honda >> 1999 >> Prelude Base, Standard >> Repair and Diagnosis >> Accessories & Equipment >> Cruise Control Systems >> Component Tests >> Set/Resume Switch

Set/Resume Switch

NOTE: On models with theft protection system, obtain radio security code from vehicle owner, before disconnecting battery cable.
  1. Disable air bag system. See AIR BAG RESTRAINT SYSTEMS article. Remove dashboard lower cover. Disconnect driver-side and passenger-side air bag connectors.
  2. Disconnect 4-pin combination switch harness connector from main wiring harness. Using a DVOM, check continuity between specified terminals of combination switch 4-pin connector terminals, with SET/RESUME switch in appropriate position. See COMBINATION SWITCH HARNESS CONTINUITY TEST  table. See Fig 1 . If continuity is as specified, SET/RESUME switch is okay. If continuity is not as specified, go to next step.
    COMBINATION SWITCH HARNESS CONTINUITY TEST

    Switch Position Continuity Between Terminals No.
    Set (ON) 2 & 3
    Resume (OFF) 1 & 3
  3. Remove steering column covers. Disconnect combination switch 4-pin connector from cable reel. Using a DVOM, check continuity between terminals of combination switch harness connectors. See Fig 2 . If continuity does not exist between specified terminals of combination switch harness connectors, replace combination switch harness. If continuity exists between specified terminals, go to next step.
  4. Remove SET/RESUME switch from steering wheel. Using a DVOM, check for continuity between SET/RESUME switch terminals, with SET/RESUME switch in appropriate position. See Fig 3 . See SET/RESUME SWITCH CONTINUITY TEST  table. If continuity is not as specified, replace SET/RESUME switch. If continuity is as specified, replace cable reel. See AIR BAG RESTRAINT SYSTEMS article.
  5. Ensure air bag restraint system is operating properly. Ensure all air bag components are connected. Connect positive battery cable. Connect negative battery cable. While observing SRS indicator light, turn ignition on. SRS indicator light should illuminate for about 6 seconds, and then go off.
SET/RESUME SWITCH CONTINUITY TEST

Switch Position Continuity Between Terminals No.
Set (ON) 1 & 3
Resume (OFF) 1 & 2
Fig 1: Identifying Combination Switch 4-Pin Connector Terminals
G98D04938Courtesy of AMERICAN HONDA MOTOR CO., INC.
Fig 2: Identifying 4-Pin Connector Terminals Of Combination Switch Harness
G97D11554Courtesy of AMERICAN HONDA MOTOR CO., INC.
Fig 3: Identifying Terminals Of Set/Resume Switch
G98H04935Courtesy of AMERICAN HONDA MOTOR CO., INC.
scientia non olet · About LEMON Manuals