LEMON Manuals: Even more car manuals for everyone
Home >> Honda >> 1999 >> Prelude Base, Automatic >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - System & Component Testing >> Idle Control System >> Power Steering Pressure Switch Signal >> Civic (D16Y5 Engine With M/T) & Prelude

Civic (D16Y5 Engine With M/T) & Prelude

  1. Turn ignition on. Using backprobe set, measure voltage between PCM 32-pin connector "A" terminals No. 9 (Brown/Black wire) and 31-pin connector "C" terminal No. 16 (Green wire). If voltage is one volt or more, go to step  3. If voltage is less than one volt, go to next step.
    NOTE: DO NOT hold steering wheel in full lock position for more then 5 seconds.
  2. Start engine. Turn steering wheel slowly to full lock position. Using backprobe set, measure voltage between PCM 32-pin connector "A" terminals No. 9 (Brown/Black wire) and 31-pin connector "C" terminal No. 16 (Green wire). If battery voltage is present, PSP switch signal is okay. If battery voltage is not present, go to step  5.
  3. Turn ignition off. Disconnect PSP switch 2-pin connector. Switch is located on high pressure hose next to steering gear. Connect a fused jumper wire between two PSP switch harness connector terminals. Turn ignition on. Using backprobe set, measure voltage between PCM 32-pin connector "A" terminals No. 9 (Brown/Black wire) and 31-pin connector "C" terminal No. 16 (Green wire). Go to next step.
  4. If voltage is one volt or more, repair open in Green wire between PSP switch and PCM 31-pin connector "C". If wire is okay, check for open in Black wire between PSP switch and ground connection. On all Civic except Continuously Variable Transmission (CVT), ground connection is located on right side of engine, on thermostat housing, under engine coolant temperature switch. On Civic equipped with CVT, ground connection is located at right front of engine between air cleaner box and starter. On Prelude, ground connection is located on right side of engine, just behind and below distributor cap, under VTEC pressure switch. See WIRING DIAGRAMS article. If voltage is less than one volt, replace PSP switch.
  5. Turn ignition off. Disconnect PSP switch 2-pin connector. Switch is located on high pressure hose next to steering gear. Turn ignition on. Measure voltage between PCM 32-pin connector "A" terminals No. 9 (Brown/Black wire) and 31-pin connector "C" terminal No. 16 (Green wire). If battery voltage is present, replace PSP switch. If battery voltage is not present, go to next step.
  6. Turn ignition off. Disconnect PCM 31-pin connector "C". Check for continuity between ground and PCM 31-pin harness connector "C" terminal No. 16 (Green wire). If continuity exists, repair short in Green wire between PSP switch connector and PCM 31-pin connector "C". See WIRING DIAGRAMS article. If continuity does not exist, substitute a known-good PCM and recheck. On Prelude, see SUBSTITUTING PCM in SELF-DIAGNOSTICS - INTRODUCTION article. If symptom or indication goes away, replace original PCM.
scientia non olet · About LEMON Manuals