Common Specs & Procedures
PRELUDE COMMON SPECS & PROCEDURES
| System | Specification/Procedure | ||
|---|---|---|---|
| Air Conditioning | |||
| Service | A/C SYSTEM SPECIFICATIONS | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Axle Nut/Hub Nut | N/A | ||
| Battery | CAPACITIES | ||
| Brakes | |||
| Bleeding Sequence | |||
| With ABS | BLEEDING BRAKE SYSTEM | ||
| Without ABS | BLEEDING BRAKE SYSTEM | ||
| Disc Brakes | |||
| Service Specifications | DISC BRAKE SPECIFICATIONS | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Drum Brakes | |||
| Service Specifications | DRUM BRAKE SPECIFICATIONS | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Charging | |||
| Generator | Refer to the GENERATOR OUTPUT SPECIFICATIONS table under GENERATOR/REGULATOR TEST | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Drive Belts | |||
| Adjustment | BELT INSPECTION & ADJUSTMENT | ||
| Drive Belt Routing | DRIVE BELT ROUTING | ||
| Engine Cooling | |||
| General Service Specifications | COOLING SYSTEM SPECIFICATIONS | ||
| Radiator Cap Pressure | 14-18 psi | ||
| Thermostat R & I | THERMOSTAT | ||
| Water Pump R & I | WATER PUMP | ||
| Engine Mechanical | |||
| Compression | ENGINE COMPRESSION | ||
| Oil Pressure | |||
| H22A4 Engine With M/T & ATTS | Measure oil pressure with engine temperature at 176°F (80°C). At idle, minimum oil pressure should be 10 psi (0.7 kg/cm2 ). At 3000 RPM, oil pressure should be 50 psi (3.5 kg/cm2 ). | ||
| Except H22A4 Engine With M/T & ATTS | Measure oil pressure with engine temperature at 176°F (80°C). At idle, minimum oil pressure should be 10 psi (0.7 kg/cm2 ). At 3000 RPM, oil pressure should be 50 psi (3.5 kg/cm2 ). | ||
| Overhaul | ENGINE SPECIFICATIONS | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Fluid Specifications | See FLUIDS under MAINTENANCE/FLUIDS tab. From within Manager or Service Writer, click the "30/60/90 Interval" or "Maint." button. | ||
| Flywheel/Flex Plate/Drive Plate Torque | 55 Ft. Lbs. (74 N.m) Drive Plate 76 Ft. Lbs. (103 N.m) | ||
| Fuel System | |||
| Pressure Specification | FUEL PUMP | ||
| Fuel Pressure Test Procedure | PRESSURE TESTING | ||
| Fuel Filter Location | FUEL FILTER | ||
| Fuel Filter R & I | FUEL FILTER | ||
| Ignition | |||
| Firing Order & Cylinder Identification | FIRING ORDER & TIMING MARKS | ||
| Ignition Wires (Resistance) | HIGH TENSION WIRE RESISTANCE | ||
| Ignition Wires (Routing) | FIRING ORDER & TIMING MARKS | ||
| Spark Plug | SPARK PLUGS | ||
| Starting | |||
| Starter | STARTER SPECIFICATIONS | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Wheel Alignment | |||
| Adjustment Specifications | WHEEL ALIGNMENT SPECIFICATIONS | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Wheel & Tire | |||
| Wheel Lug Nut Torque | 80 Ft. Lbs. (108 N.m) | ||