Power Mirror Actuator Test
Turn ignition off. Remove inner door panel. See DOOR PANEL under REMOVAL & INSTALLATION. Disconnect 3-pin harness connector from mirror actuator. Using fused jumper wires, connect battery voltage and ground to mirror actuator connector terminals as specified. See POWER MIRROR ACTUATOR TEST table. See Fig 1 . Observe mirror movement. If operation is not as specified, replace mirror actuator.
POWER MIRROR ACTUATOR TEST
| Apply 12 Volts To Pin No. | Ground Pin No. | Mirror Operation |
|---|---|---|
| 1 | 2 | Up |
| 2 | 1 | Down |
| 2 | 3 | Left |
| 3 | 2 | Right |