Fuel Injected: Accord

Remove rubber cap from inspection window on bellhousing of cylinder block. Start and warm engine to normal operating temperature (cooling fan comes on). Connect a jumper wire between Orange/Red and Green/White wire terminals of ignition timing check connector located in passenger-side kick panel. See Fig 1 .

Fig 1: Locating Ignition Timing Check Connector (Accord)
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Connect a timing light to No. 1 spark plug wire. Check base ignition timing with timing light. See IGNITION TIMING table. TDC mark is on flywheel for manual transmissions and on drive plate for automatic transmissions. See Fig 2 .
Loosen hold-down bolts, and rotate distributor to adjust timing. Tighten distributor hold-down bolts to specification after adjustment. See TORQUE SPECIFICATIONS table at end of article. Recheck timing.

Remove timing light. Remove jumper wire from ignition timing check connector. Install rubber cap to inspection window.

Fig 2: Locating Ignition Timing Marks (Accord)

Courtesy of AMERICAN HONDA MOTOR CO., INC.

IGNITION TIMING (Degrees BTDC@RPM)

Application

Setting

Accord

13-17@700-800

Civic

16-20@700-800

CRX

1.5L PFI

⁽¹⁾ 12-16@550-650

1.5L TBI

16-20@675-775

1.6L PFI

16-20@700-800

Prelude

13-17@700-800

⁽¹⁾	600-700 RPM on California vehicles.