LEMON Manuals: Even more car manuals for everyone
Home >> Honda >> 1990 >> Prelude Si, Automatic >> Repair and Diagnosis >> Brakes >> Traction Control >> Anti-Lock Brake System >> Diagnosis & Testing >> Abs Function Test >> Testing

Abs Function Test: Testing

  1. Turn ignition off. Connect ABS Tester (07HAJ-SG0010A) to MD13Pink 6-pin test connector, located on passenger's side of center console. Start engine. Release parking brake. Place mode selector to "1". Push start test button. See Figure . Test-in-progress light should come on. Within 1-2 seconds, all 4 monitor lights should come on. If tester lights DO NOT illuminate, ABS tester is faulty.
  2. If ANTI-LOCK warning light comes on, 6-pin connector or ABS tester harness is faulty. Turn mode selector to "2". Press brake pedal. Push start test button. The ANTI-LOCK warning light should not come on and kickback should be felt on brake pedal.
  3. If ANTI-LOCK warning light comes on or kickback is not felt, see ANTI-LOCK WARNING LIGHT under TROUBLE SHOOTING. Place mode selector in "3", "4", "5" then "6". Repeat step 2) for each test mode. Results should be same as in test mode "2". If same test results are not achieved, see ANTI-LOCK WARNING LIGHT under TROUBLE SHOOTING.
  4. Breakdown of each test mode is as follows:
scientia non olet · About LEMON Manuals