LEMON Manuals: Even more car manuals for everyone
Home >> Honda >> 1989 >> Prelude S, Automatic >> Repair and Diagnosis >> Engine Performance >> System >> Tests W/Codes - Fuel Injected >> Testing - Trouble Code Tests >> Code 9: TDC/Crank/CYL Sensor

Code 9: TDC/Crank/CYL Sensor

  1. Turn ignition off. Remove clock fuse in the under-hood relay box for 10 seconds to reset ECU. Start engine and observe "CHECK ENGINE" light. If light is off, problem is intermittent. Test drive and check again.
  2. If light is on, turn ignition off. Disconnect 2-wire sensor connector. Measure resistance across sensor terminals. If reading is not 700-1000 ohms, replace CYL sensor assembly. If reading is within specification, proceed to next step.
  3. Check continuity between ground and each sensor terminal. If continuity exists, replace CYL sensor assembly. If no continuity exists, proceed to next step.
  4. Reconnect sensor connector. Attach ECU test harness to main wire harness side only. Check resistance between connector terminals C1 and C2. Resistance should be 700-1000 ohms.
  5. If resistance is not within specification, repair open or short in Orange and/or White wires. If resistance is within specification, substitute a known good ECU and retest. If condition is rectified, replace original ECU.
scientia non olet · About LEMON Manuals