Clutch Assembly: Installation
- Align flywheel dowels with dowel holes in clutch cover. Using clutch alignment tool and ring gear holder, install disc and pressure plate. Tighten bolts evenly, in a crisscross pattern, to final torque. Ensure that 2 dowel pins are installed in clutch housing.
- Clean release bearing sliding surfaces. Apply molybdenum grease to release bearing contact points, clutch disc and transaxle mainshaft splines. Do not allow oil, grease or dirt to contaminate clutch component friction surfaces. To complete installation, reverse removal procedure. Ensure drain plug is tight and refill transaxle. Adjust clutch pedal height, travel and freeplay.
CAUTION:
New spring clips must be used on both axle shafts. Slide axles in until spring clips engage differential.