Pressure Test
- Attach jumper wire between 2 Black/Yellow wires in fuel pump cut-off relay connector. Disconnect fuel hose to carburetor and cap "T" fitting. Install pressure gauge to fuel hose. Turn ignition switch on and check for normal pressure of 2-3 psi (.14-.21 kg/cm2 ).
- Remove pressure gauge and hold measuring cup under fuel hose. Turn ignition switch to "ON" position. Measure amount of fuel flow in 60 seconds with 10 volts minimum battery voltage. Flow should as indicated in FUEL FLOW SPECIFICATIONS chart. If not replace fuel pump.
FUEL FLOW SPECIFICATIONS
| Application | Volume: oz./min.(cc/min.) |
|---|---|
| Accord | 15(450) |
| Prelude | 23(680) |