LEMON Manuals: Even more car manuals for everyone
Home >> Geo >> 1996 >> Tracker Base, 2D Utility, 4WD, Automatic >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Tests W/Codes >> Circuit Tests >> DTC P0335 - CKP Sensor Circuit Malfunction

DTC P0335 - CKP Sensor Circuit Malfunction

  1. Turn ignition off. Disconnect PCM harness connectors. Using an ohmmeter, measure resistance between PCM harness connector "B", terminals No. 16 Black wire and No. 17 White wire. See Figure . If resistance is 360-460 ohms, go to next step. If resistance is not as specified, go to step 3).
  2. Check CKP sensor installation and condition of teeth on crankshaft pulley. Repair as necessary. If CKP sensor and crankshaft pulley are okay, check for poor connections at PCM. Repair as necessary. If PCM connections are okay, replace PCM. Retest system.
  3. Disconnect CKP sensor harness connector. Using an ohmmeter, measure resistance between CKP sensor terminals. If resistance is 360-460 ohms, repair open in CKP sensor circuit. If resistance is not as specified, replace CKP sensor. Retest system.
scientia non olet · About LEMON Manuals