Code 7, Shorted Isolation Solenoid Circuit
- Turn ignition off. Disconnect pressure limit valve connector. Measure resistance between pressure limit valve connector terminals No. 1 (Green wire) and No. 4 (Black wire).
- If resistance is less than 3 ohms, replace pressure limit valve. If resistance is 3-6 ohms, disconnect RWAL EBCM connector. Measure resistance between RWAL EBCM harness connector terminal No. 1 (Green wire) and ground.
- If resistance is greater than 20,000 ohms, replace RWAL EBCM. See RWAL ELECTRONIC BRAKE CONTROL MODULE under REMOVAL & INSTALLATION. If resistance is less than 20,000 ohms, repair short to ground in RWAL EBCM harness Green wire.