LEMON Manuals: Even more car manuals for everyone
Home >> Geo >> 1992 >> Metro LSi, 2D Hatchback, Standard >> Repair and Diagnosis >> Electrical >> Starter >> Starter - Direct Drive >> On-Vehicle Testing >> Cranking Test

Cranking Test

  1. With starter installed, connect voltmeter and ammeter to battery. See Fig 1. Disconnect ignition coil secondary wire from distributor cap and attach to ground. Crank engine and observe meters.
  2. Cranking voltage should be at least 9.5 volts. Current draw should be less than 270 amps. If readings are not as specified, replace starter.
Fig 1: Performing Starter Cranking Test (Typical)
G29599Courtesy of AMERICAN HONDA CO., INC.
scientia non olet · About LEMON Manuals