LEMON Manuals: Even more car manuals for everyone
Home >> Geo >> 1991 >> Tracker Base, RWD >> Repair and Diagnosis >> Engine Performance >> Remove, Overhaul & Install >> Engine Controls - Remove/Install/Overhaul >> Pick-Up Coil/Crank Angle Sensor >> Engine Controls - Remove/Install/Overhaul >> Removal & Installation

Removal & Installation

Remove distributor cap and rotor. Remove screws holding pick-up coil to base plate. Disconnect pick-up coil/crank angle sensor connector and remove pick-up coil/crank angle sensor. To install, reverse removal procedure. Adjust air gap to specification. See PICK-UP COIL/CRANK ANGLE SENSOR AIR GAP table.

PICK-UP COIL/CRANK ANGLE SENSOR AIR GAP

Application Clearance In. (mm)
All Models .008-.016 (.20-.41)
scientia non olet · About LEMON Manuals