LEMON Manuals: Even more car manuals for everyone
Home >> Geo >> 1990 >> Tracker Base, Standard >> Repair and Diagnosis >> Engine Performance >> Remove, Overhaul & Install >> Engine Controls - Remove/Install/Overhaul >> Injector (TBI) R & I >> Installation

Injector (TBI) R & I: Installation

  1. Apply thin coat of fuel to new injector "O" rings. Install "O" rings on injector. Insert injector into throttle body. Carefully install injector wiring harness grommet to housing.
  2. Apply thread locking compound to mounting screws and install injector cover. Tighten cover screws to 31 INCH lbs. (3.5 N.m). Connect fuel line with new "O" ring.
  3. Check for fuel leaks by activating fuel pump using ignition switch. If fuel leaks are not present, install air intake duct case.
FUEL PUMP RELAY LOCATIONS

Model Location
Tracker Control Relay (containing 2 connectors) is under left side of dash, near kick panel
scientia non olet · About LEMON Manuals