LEMON Manuals: Even more car manuals for everyone
Home >> Genesis >> 2024 >> GV80 3.5T Advanced >> Repair and Diagnosis >> Body & Frame >> Door Locks >> Identity Authentication Unit Diagnosis >> DTC B165A-00: BLE Module Fault >> DTC Information And Inspection >> DTC Setting Condition

DTC Setting Condition

Troubleshooting Condition Possible Cause
Main Action
  • Monitor the DTC status
  1. Data learning has not taken place after replacing the relevant controller(s)
    • No learning data is available after placing the new IAU(1)
    • No learning data is available after placing the new BLE(2) Module
    • No learning data is available after placing both the new IAU(1) and the new BLE(2) module
  2. BLE(2) Module errors
  3. Voltage errors of the battery (9V or less/16V or more)
Prerequisite Condition
  • Turn the ignition switch ON
Threshold Value
  • BLE(2) errors
  • No learning between BLE(2) and IAU(1)
  • Above BLE(2) input voltage

    (Maintain 9V or below & 16V or more for 2 sec)
Diagnosis Time
  • Immediately
DTC Clearing
  • Immediately after receiving a sign of "Normal Operation" from BLE(2) Module
NOTE:
(1) "Identity Authentication Unit"

(2) "Bluetooth Low Energy"
scientia non olet · About LEMON Manuals