Monitor DTC Status
- Connect GDS and select the "DTC Analysis" mode.
- Click the "DTC Status" to check the DTC information.
- Read the "DTC Status" parameter, and Record all DTCs, DTC state and freeze frame data.
- Is the DTC active?
YES
- Verify the system specification of the vehicle, and conduct the "S/W Management" → "CLU Variant Coding" in line with the system specification.
NO
- This can occur when the CLU*'s memory was not cleared after the repair.
→ Go to the "VERIFICATION OF VEHICLE REPAIR " procedure.
- Inspect an intermittent fault caused by Poor Contact in CLU*'s connector.
Component Name_ETM ETM Cluster*
CLU*"INSTRUMENT CLUSTER" SD940-1, 2, 5, 6 4WD "AWD ECU" SD200-4 ECS "ECS UNIT" SD200-2 ESP
ABS
EPB"ESC MODULE" SD200-2 LKAS "MULTIFUNCTION CAMERA UNIT" SD200-2 MDPS "MDPS UNIT" SD200-2 SCC "SMART CRUISE CONTROL MODULE" SD200-2 SRSCM "SRS CONTROL MODULE" SD200-2 TCU "TCM" SD200-4 TPMS "IBU" SD200-6