LEMON Manuals: Even more car manuals for everyone
Home >> Genesis >> 2021 >> GV80 3.5T Advanced >> Repair and Diagnosis (Single Page) >> Engine Performance >> System >> Engine Control System Diagnosis - 3.5L (9 Of 9) >> DTC P24D6-00: EVAP System Pressure Sensor/Switch 'B' Circuit Range/Performance >> DTC Information And Inspection >> DTC Detecting Condition

DTC Information And Inspection: DTC Detecting Condition

Troubleshooting Condition Possible Cause
Main Action
  • Performance inspection
  1. Poor contact of connector
  2. CPSV Pressure Sensor (Ejector Pressure Sensor)
case 1 Prerequisite Condition
  • The engine revolution state
  • The difference between and difference pressure before Venturi tube between start and end value for dynamic check Venturi tube boost pressure sensor value is greater than 0 kPa
  • The pressure before venturi tube is lower than 1250 kPa
Threshold Value
  • The pressure gradient ratio is lower than 0.8 or The pressure gradient ratio is higher than 1.2
Diagnostic Time
  • Immediate
case 2 Prerequisite Condition
  • The engine revolution state
Threshold Value
  • The pressure is lower than -80 kPa or The pressure is higher than 5 kPa
Diagnostic Time
  • 5 sec
MIL
  • 2nd Driving Cycle
scientia non olet · About LEMON Manuals