TPMS Reminder Reset Procedure
System Reset
NOTE:
There is no reset procedure necessary for this TPM system. Corrected tire inflation pressure will cause the TPMS indicator to shut off once the tire pressure sensor reports to the TPMS receiver, approximately 20 minutes after the vehicle stops moving, or 20 minutes of continuous driving.
NOTE:
The low tire pressure telltale comes on for 3 seconds after the ignition switch is turned to the ON position. If the warning lights do not come on, or continuously remains on after coming on for about 3 seconds when you turned the ignition switch to the ON position, the Tire pressure System may not be working properly. On some models, a TPMS malfunction is indicated by a separate telltale, which displays the symbol "TPMS" when illuminated. When this malfunction indicator is illuminated, the system may not be able to detect or signal low tire pressure as intended.
CAUTION:
The TPMS malfunction indicator may be illuminated if the vehicle is moving around electric power supply cables or radios transmitter such as at police stations, government and public offices, broadcasting stations, military installations, airports, or transmitting towers, etc. The malfunction indicator may also illuminate if snow chains or some separately purchased devices such as notebook computers, mobile charger, remote starter, navigation etc. are used in the vehicle.
CAUTION:
If the vehicle has a failed tire sensor, it is possible for the TPMS to temporarily "learn" a sensor on another vehicle that is also equipped with the same TPM system, if closely driven to that vehicle. In rare cases, this may temporarily delay the TPMS malfunction indicator from turning on.
Sensor Registration
New tire pressure sensors must be registered to the TPM system. A Hyundai Global Diagnostic System (GDS) and GDS TPMS module are required to perform the sensor registration procedure. Select the model and ID Register, then perform the sensor registration procedure according to instructions on the GDS.
NOTE:
A modern TPMS Activation tool, such as the Snap-on TPMS3, may also be used to register the tire pressure sensors.