Repair Procedures: Cleaning
WARNING: This page is about a different variant/trim than selected.
- Remove the ETC Module.
(Refer to "Removal ")
- Keep the ETC module plate (A) open.
- Clean the pollutant in the throttle body with a soft cloth moistened by cleaning fluid.NOTE:
- Do not spray cleaning fluid directly onto ETC module. Use a lint free cloth moistened by cleaning fluid.
- Be careful not to clean the coating fluid around the shaft. If coating fluid is removed, idling control failure may occur due to inflow of foreign substance or excessive air leakage.
- After cleaning, reinstall the ETC module and then perform the ETC module learning procedure.
(Refer to "Installation ", and "Adjustment ").