LEMON Manuals: Even more car manuals for everyone
Home >> Genesis >> 2021 >> G70 2.0T, RWD, Automatic Trans >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Airbag Modules And Clock Spring >> Driver Airbag (DAB) Module And Clock Spring >> Repair Procedures >> Removal

Repair Procedures: Removal

  1. Disconnect the battery negative cable and wait for at least three minutes before beginning work.
  2. Put a flat tool (Ø4 mm) into a guide hole located in the bottom of steering wheel and press a spring.
    G14176811Courtesy of HYUNDAI MOTOR AMERICA
    G14176812Courtesy of HYUNDAI MOTOR AMERICA
    CAUTION: When put a tool into a hole, make sure not to damage an airbag cushion by a tool.
  3. Turn a steering wheel anti-clockwise, so make a guide hole (A) shown on the right side.

    Put a tool into a hole (B) and bend back a fixed DAB spring.

    Make sure to pull DAB cover when bend back the spring.

    G14176813Courtesy of HYUNDAI MOTOR AMERICA
    G14176814Courtesy of HYUNDAI MOTOR AMERICA
    NOTE: Pull the DAB cover when disengaging the DAB spring because the DAB does not pop up automatically.
  4. Release the connector locking, then disconnect the driver airbag module connector (A) and horn connector (B).
    G14176815Courtesy of HYUNDAI MOTOR AMERICA
  5. Remove the steering wheel.

    (Refer to Steering System - "STEERING WHEEL ")

  6. Loosen the steering wheel column shroud panel.

    (Refer to Steering System - "STEERING WHEEL COLUMN SHROUD PANEL ")

  7. Disconnect the clock spring and horn connector, then remove the clock spring (A).
    G14176816Courtesy of HYUNDAI MOTOR AMERICA
    G14176817Courtesy of HYUNDAI MOTOR AMERICA
scientia non olet · About LEMON Manuals