LEMON Manuals: Even more car manuals for everyone
Home >> Genesis >> 2021 >> G70 2.0T, RWD, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 11 (Front Driveshaft Assembly) >> TJ Joint >> Repair Procedures >> Removal

Repair Procedures: Removal

WARNING: This page is about a different variant/trim than selected.
NOTE:
  • Do not disassemble the BJ assembly.
  • Special grease must be applied to the driveshaft joint. Do not substitute with another type of grease.
  • The boot band should be replaced with a new one.
  1. Remove the front drive shaft.

    (Refer to "FRONT DRIVESHAFT ")

  2. Remove the clip (B) from the transmission side joint spline (A).
    G14176399Courtesy of HYUNDAI MOTOR AMERICA
  3. Remove the transmission side joint (TJ) both boot band.
    G14176400Courtesy of HYUNDAI MOTOR AMERICA
    G14176401Courtesy of HYUNDAI MOTOR AMERICA
  4. Pull the transmission side joint (TJ) boot.
  5. After removing the clip, separate from the joint (TJ) boot (A) on the transmission side. Then put aside the TJ boot and the outer race (B) of TJ after wiping the grease inside the outer race of TJ.
    G14176402Courtesy of HYUNDAI MOTOR AMERICA
    NOTE:
    • Be careful not to damage the boot.
    • As shown below, mark (D) on the roller (A) of trunnion assembly, outer race (B) of TJ and spline part (C) for assembling work.
      G14176403Courtesy of HYUNDAI MOTOR AMERICA
  6. Remove the circlip (A) by using the snap ring plier (-) driver.
    G14176404Courtesy of HYUNDAI MOTOR AMERICA
  7. Clean the trunnion assembly.
  8. Remove the transmission side joint (TJ) boot (A).
    NOTE:
    • For reusing the boot (A), wrap tape (B) around the driveshaft splines (C) to protect the boot (A).
    G14176405Courtesy of HYUNDAI MOTOR AMERICA
scientia non olet · About LEMON Manuals