LEMON Manuals: Even more car manuals for everyone
Home >> Genesis >> 2021 >> G70 2.0T, RWD, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 11 (Front Driveshaft Assembly) >> TJ Joint >> Repair Procedures >> Installation

Repair Procedures: Installation

WARNING: This page is about a different variant/trim than selected.
  1. Wrap tape around the driveshaft spline (TJ) to prevent damage to the boot.
  2. Install the TJ boot band and then TJ boot.
  3. Using the alignment marks (D) made during disassembly as a guide, install the spider assembly (A) and snap ring (B) on the driveshaft splines (C).
    G14176406Courtesy of HYUNDAI MOTOR AMERICA
    G14176407Courtesy of HYUNDAI MOTOR AMERICA
  4. Add specified grease to the joint boot as much as it was wiped away at inspection.
  5. Install the both boot band.
  6. To control the air in the TJ boot, keep the specified distance between the boot bands when they are tightened.
    Engine Distance (L) mm (in.)
    LH side RH side
    Gasoline 2.0 479.9 (18.8937) 463.3 (18.2402)
    Gasoline 3.3 479.9 (18.8937) 463.4 (18.2441)
    G14176408Courtesy of HYUNDAI MOTOR AMERICA
  7. Using the SST (09495-3K000), secure the TJ boot bands.

    Clearance (A)  : 2.0 mm (0.0787 in.) or less

    G14176409Courtesy of HYUNDAI MOTOR AMERICA
    G14176410Courtesy of HYUNDAI MOTOR AMERICA
  8. Install the front driveshaft.

    (Refer to "FRONT DRIVESHAFT ")

scientia non olet · About LEMON Manuals