LEMON Manuals: Even more car manuals for everyone
Home >> Genesis >> 2020 >> G80 3.8, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 20 (Engine Control System - 3.3L) >> Oil Pressure Sensor (OPS) >> Repair Procedures >> Inspection

Repair Procedures: Inspection

WARNING: This page is about a different variant/trim than selected.
  1. Turn the ignition switch OFF.
  2. Disconnect the OPS connector.
  3. Remove the OPS (Refer to "REMOVAL ").
  4. After immersing the thermistor of the sensor into engine coolant, measure resistance between the OPS terminals 1 and 2.
  5. Check that the Resistance is within the Specification.

    Specification:  Refer to "SPECIFICATIONS "

scientia non olet · About LEMON Manuals