LEMON Manuals: Even more car manuals for everyone
Home >> Genesis >> 2020 >> G70 3.3T Elite, AWD >> Repair and Diagnosis >> Brakes >> Traction Control >> Electronic Stability Program (Esp) System >> Front Wheel Speed Sensor >> Repair Procedures >> Removal

Repair Procedures: Removal

  1. Turn ignition switch OFF and disconnect the negative (-) battery cable.
    CAUTION:
    • Wait at least 30 seconds after separating the cable.
  2. Loosen the wheel nuts slightly.

    Raise the vehicle, and make sure it is securely supported.

  3. Remove the front wheel and tire (A) from front hub.
    NOTE:
    • Be careful not to damage the hub bolts when removing the front wheel and tire (A).
    G13541039Courtesy of HYUNDAI MOTOR AMERICA
  4. Remove the wheel speed sensor connector (A).
    G13541040Courtesy of HYUNDAI MOTOR AMERICA
  5. Disconnect the wheel speed sensor bolt and then wheel speed sensor (A).

    Tightening torque: 

    6.9 - 10.8 N.m (0.7 - 1.1 kgf.m 5.1 - 7.9 ft.lb)

G13541041Courtesy of HYUNDAI MOTOR AMERICA
scientia non olet · About LEMON Manuals