LEMON Manuals: Even more car manuals for everyone
Home >> Genesis >> 2019 >> G90 5.0 Ultimate, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 69 (Heater & A/C Control Unit) >> Heater & A/C Control Unit >> Repair Procedures >> Replacement

Repair Procedures: Replacement

WARNING: This page is about a different car, the 2017 Genesis G80. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Put on gloves to protect your hands.
NOTE:
  • Use a plastic panel removal tool to remove interior trim pieces to prevent damage to the surface.
  • Take care not to bend or scratch the trim and panels.
  1. Disconnect the negative (-) battery terminal.
  2. Remove the crash pad side garnish assembly [RH]

    (Refer to Body - "CRASH PAD SIDE GARNISH ASSEMBLY [Rh]")

  3. Remove the heater & A/C controller unit from the center fascia after loosening the mounting screws (A).
    G11069140
    G11069141
  4. Disconnect the A/C & heater controller connectors (A).
    G11069142
  5. Remove the heater & A/C controller unit from the center fascia panel after loosening the mounting screws.
    G11069143
  6. Install in the reverse order of removal.

    Information 

    • Make sure the connector is connected properly.
    • Replace any damaged clips.
scientia non olet · About LEMON Manuals