Repair Procedures: Disassembly

WARNING: This page is about a different car, the 2017 Genesis G80. However, it is still accessible from the selected car via links, so may be relevant.

Remove the engine room under cover.
Loosen the drive belt.
(Refer to TIMING SYSTEM - 5.0L Engine Mechanical System )
Remove the center bolt (A) while holding the pulley with a disc & hub assembly.
Tightening torque:

10 - 15 N.m (1.0 - 1.5 kgf.m, 7.4 - 11.0 lb-ft)

Courtesy of
Loosen the mounting bolts and then remove the disc & hub assembly (A).

Courtesy of
Remove the pulley (B) after removing the snap ring (A) with snap ring pliers.

Courtesy of
NOTE:
- Be careful not to damage the pulley and compressor during disassembly/reassembly.
- Once the snap ring is removed, replace it with a new one.
Reassemble in the reverse order of disassembly.

NOTE:

Clean the pulley and compressor sliding surfaces with non-petroleum solvent.
Install a new snap ring, and make sure they are fully seated in the groove.
Make sure that the pulley turns smoothly after reassembly.