Repair Procedures: Replacement
WARNING: This page is about a different car, the 2017 Genesis G80. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
- When installing the belt, make sure not to damage the pretensioner.
- Remove the front anchor seat belt (A).NOTE: How to detach the anchor seat belt
- Expose the red-colored indicator pin (A) by pushing the slot hole with a Ø 1.5mm pointed tool in illustration below.CAUTION: Be careful not to scratch the anchor cover with a pointed tool when pushing the slot hole.
- Put a (-) driver (Ø4mm) into a latch hole (2) and turn it clockwise.
- Remove the connector by pulling seat belt (3).
NOTE: When connecting the anchor connector, securely connect it until "click" sound is heard. - Expose the red-colored indicator pin (A) by pushing the slot hole with a Ø 1.5mm pointed tool in illustration below.
- After opening the seat track cover and loosening the mounting bolts, remove the front seat assembly.
Tightening torque:
49.0 - 63.7 N.m (5..0 - 6.5 kgf.m, 36.2- 47.0 lb-ft)
[Front]
[Rear]
- Pull up the front seat headrest (A).
- Disconnect the front seat integration connector (A).
- Install in the reverse order of removal.
information
The installation procedures of seat mounting bolts
- Push the seat to the rear end of slides and initially tighten the front mounting bolts.
- Push the seat to the front end of slides and completely tighten the rear mounting bolts.
- Send the seat to the rear end again to completely tighten the front mounting bolts.
- Check the seat for smooth movement.
- For the non-automatic slide seats, check the seats are fixed at each designated fixing position.
CAUTION:- When coupling the tongue to the buckle, be careful not to twist the belt.