LEMON Manuals: Even more car manuals for everyone
Home >> Genesis >> 2019 >> G90 5.0 Ultimate, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 41 (Tire Pressure Monitoring System) >> TPMS Receiver >> Repair Procedures >> Replacement

Repair Procedures: Replacement

WARNING: This page is about a different car, the 2017 Genesis G80. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative (-) battery cable.
  2. Remove the crash pad.

    (Refer to CRASH PAD Body )

  3. Remove the connector.
  4. Remove the bracket (B) and receiver (C) by loosening the nut (A).

    Tightening torque: 

    3.9 ~ 5.9N.m (0.4 ~ 0.6kgf.m, 2.9 ~ 4.3lb-ft)

    G11340035Courtesy of
  5. Install in the reverse order of removal.
  6. Re-connect the battery, and then turn on the ignition.
    NOTE: Firmly fasten the receiver connector until you hear a click.
  7. Replace the receiver, and then perform the learning process using a diagnostic instrument (GDS).
scientia non olet · About LEMON Manuals