Repair Procedures: Replacement

WARNING: This page is about a different car, the 2017 Genesis G80. However, it is still accessible from the selected car via links, so may be relevant.

Remove the handle cover (B) by pushing the button (A) located in the lower part of the handle cover using a key or flat head screwdriver.
Remove the plug hole (B).
After loosening the mounting bolt, remove the front door lock (A).
Tightening torque:

6.9 - 10.8 N.m (0.7 - 1.1 kgf.m, 5.1 - 8.0 lb-ft)
Remove the front door outside handle (A) by sliding it forward.
Disconnect the front door outside handle connector (A).
Install in the reverse order of removal.

Information

Be sure to install the outside handle pad (A) between the outside handle and the door panel.
Make sure the connector is connected properly.
Make sure the door locks/unlocks and opens/closes properly.
Make sure the handle is assembled without any gaps.