Repair Procedures: Replacement: [2WD]
WARNING: This page is about a different car, the 2017 Genesis G80. However, it is still accessible from the selected car via links, so may be relevant.
- Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported.
- Remove the front wheel and tire (A) from the front hub.NOTE: Be careful not to damage the hub bolts when removing the front wheel and tire.
- Remove the brake caliper assembly.
(Refer to Brake System - "FRONT DISC BRAKE ")
- Remove the brake disc by loosening the screw (A).
Tightening toque
A:4.9-5.9 N.m (0.5-0.6 kgf.m, 3.6-4.3 lb-ft)
- Remove the wheel speed sensor by loosening the wheel speed sensor bracket bolt (A) and wheel speed sensor mounting bolt (B).
:Tightening toque
6.9-10.8 N.m (0.7-1.1 kgf.m, 5.1-8.0 lb-ft)
- Remove the tie rod end ball joint from the knuckle.
- Remove the split pin.
- Remove the castle nut.
- Disconnect the ball joint (A) from knuckle (B) using the special tool (09568-2J100).
NOTE: Apply a few drops of oil to the special tool. (Boot contact part) - Loosen the tension arm mount bolt (A), and then remove the tension arm (B).
Tightening torque:
88.3 - 107.9 N.m (9.0 - 11.0 kgf.m, 65.1 - 79.6 lb-ft)
- Using the special tool (09568-2J100), remove the lateral arm from the knuckle.
- Using the special tool (09568-2J100), separate the upper arm from the knuckle and then remove the knuckle assembly.
Tightening torque:
78.5 - 88.3 N.m (8.0 - 9.0 kgf.m, 57.9 - 65.1 lb-ft)
- Loosen the hub mounting bolt and then remove the hub assembly (B) from the knuckle (A).
Tightening torque:
88.3 - 107.9 N.m (9.0 - 11.0 kgf.m, 65.1 - 79.6 lb-ft)
- Loosen the bolt and then remove the dust cover (A).
Tightening torque:
6.9 - 10.8 N.m (0.7 - 1.1 kgf.m, 5.1 - 8.0 lb-ft)
- Install in the reverse order of removal.NOTE: Use a SST (09581-11000) when installing the brake caliper assembly.
(Refer to Brake System - "FRONT DISC BRAKE ") - Check the front alignment.
(Refer to ALIGNMENT )