Repair Procedures: Replacement
CAUTION:
- Put on gloves to prevent hand injuries.
NOTE:
- When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
- When removing the interior trim pieces, use a plastic panel removal tool not to damage the surface.
- Take care not to bend or scratch the trim and panels.
- Remove the front seat.
(Refer to Front Seat - "FRONT SEAT ASSEMBLY ")
- Remove the rear seat.
(Refer to Rear Seat - "REAR SEAT ASSEMBLY ")
- Remove the front pillar trim.
(Refer to Interior Trim - "FRONT PILLAR TRIM ")
- Remove the canter pillar upper trim.
(Refer to Interior Trim - "CENTER PILLAR TRIM ")
- Remove the rear pillar trim.
(Refer to Interior Trim - "REAR PILLAR TRIM ")
- Remove the Sun-Visor and retainer.
(Refer to Roof Trim - "SUN-VISOR ")
- Remove the assist handle.
(Refer to Roof Trim - "ASSIST HANDLE ")
- Remove the overhead console lamp.
(Refer to Body Electrical System - "OVERHEAD CONSOLE LAMP ")
- Using a screwdriver or remover, remove the inside rear view mirror (A).
- Disconnect the inside rear view mirror connector (A), LDWS connector (B) and rain sensor (C).
- Disconnect the roof trim main connectors (A) and the mounting clips in the front pillar.
[Driver's]
[Passenger's]
- Disconnect the connectors (A) and the mounting clips in the rear pillar.
[LH]
[RH]
- Using a clip remover, detach the roof trim assembly pin-type retainers (A).
- Remove the roof trim assembly (A) from the body panel and then carry it out of the vehicle through the rear door.
- Remove roof trim wiring harness (A) from the roof trim (B).NOTE:
- Take care not to damage the roof trim wiring harness (A) when removing.
Information
- When installing the roof trim wiring harness (A) on the roof trim, apply the hot melt continuously by using the hot melt gun tool.
- Put anti-noise pad on roof trim to prevent the noise.
- To install, reverse the removal procedure.
Information
- Make sure the connector is connected properly.
- Replace any damaged clips.