Repair Procedures: Replacement
CAUTION:
- Put on gloves to prevent hand injuries.
NOTE:
- When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
- When removing the interior trim pieces, use a plastic panel removal tool not to damage the surface.
- Take care not to bend or scratch the trim and panels.
- Remove the rear seat cushion assembly.
(Refer to Rear Seat - "REAR SEAT ASSEMBLY ")
- Remove the rear seat back assembly.
(Refer to Rear Seat - "REAR SEAT ASSEMBLY ")
- Remove the rear door scuff trim.
(Refer to Interior Trim - "DOOR SCUFF TRIM ")
- Remove the rear pillar trim.
(Refer to Interior Trim - "REAR WHEEL HOUSE TRIM ")
- Remove the rear wheel house trim.
(Refer to Interior Trim - "REAR WHEEL HOUSE TRIM ")
- Remove the rear console assembly (A).
(Refer to Floor Console - "FLOOR CONSOLE ASSEMBLY ")
- Using a screwdriver or remover, remove the center seat belt cover (A).
- After loosening the mounting screws, remove the rear package tray trim (A).
- To install, reverse the removal procedure.
Information
- Make sure the connector is connected properly.
- Replace any damage clips.