LEMON Manuals: Even more car manuals for everyone
Home >> Genesis >> 2019 >> G80 3.8, RWD >> Repair and Diagnosis >> Brakes >> Traction Control >> Electronic Stability Control Diagnosis >> DTC C1260: Steering Angle Sensor Circuit-Signal >> DTC Information >> DTC Detecting Condition

DTC Information: DTC Detecting Condition

Item Detecting Condition Possible Cause
DTC Strategy
  • Signal Monitoring
  1. Incorrect calibration
  2. Improper installation of steering angle sensor
  3. Faulty steering angle sensor
Enable Conditions
  • During straight driving, If the steering wheel angle is larger than 55 degree.
  • When the steering wheel angle is out of sensor spec.
  • When the difference between estimated angle and measured angle of the SAS sensor is lager than 50deg/s, if the fault condition exists uninterrupted for 1.5 sec.
  • In case that diagnostic signal fault of SAS was happened for more than 100 ms within normal voltage condition.
  • When the steering wheel angle is under 3deg during left/right curve.
Fail Safe
  • Inhibit the ESP (ESC)/DBC control and allow the ABS/EBD control
  • The ESP (ESC)/DBC warning lamp is activated
scientia non olet · About LEMON Manuals