Wheel Speed Sensor Circuit Check

Lift the vehicle.
IG "ON".
Turn the wheel by hand.
Measure waveform between signal terminal of the Wheel Speed Sensor (RL) harness connector and chassis ground with oscilloscope.
Specification: High: approx. 11.5V, Low: approx. 10.9V (the Voltage could be Varied With Battery Voltage)
Is the measured waveform within specifications?
YES
- Fault is intermittent caused by poor connection in Wheel Speed Sensor harness (RL). Go to "VERIFICATION OF VEHICLE REPAIR " procedure.
NO
- Substitute with a known-good Wheel Speed Sensor and check for proper operation. If problem is corrected, replace REAR WHEEL SPEED SENSOR and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.