Repair Procedures: Inspection
WARNING: This page is about a different variant/trim than selected.
Information
CAUTION:
Inspect the connector thoroughly for looseness, poor connection, bending, corrosion, contamination, deformation, or damage.
- Disconnect the parking switch connector.
- Turn Ignition "ON", & engine "OFF".
- Measure the each signal in "P" range or "not p" range.
Signal code table
SIGNAL CODE DESCRIPTION
| Signal | P | Not P |
|---|---|---|
| S1 | 10 - 38.4% | 41.1 - 90% |
| S2 | 90 - 61.6% | 58.9 - 10% |
Connection table
PIN CONNECTION DESCRIPTION
| Pin | Connection information |
|---|---|
| 1 | Ground (Ps, Ns) |
| 2 | Ps |
| 3 | - |
| 4 | Ns |
| 5 | Power (5V) |
| 6 | Ground (5V) |
| 7 | S1 |
| 8 | S2 |