Repair Procedures: Disassembly

WARNING: This page is about a different variant/trim than selected.

Disconnect the M-terminal from the magnet switch assembly.

Courtesy of HYUNDAI MOTOR AMERICA
After loosening the 3 screws (A), detach the magnet switch assembly (B).

Courtesy of HYUNDAI MOTOR AMERICA
Loosen the through bolts (A).

Courtesy of HYUNDAI MOTOR AMERICA
Remove the brush holder assembly (A), yoke (B) and armature (C).

Courtesy of HYUNDAI MOTOR AMERICA
Remove the shield (A).

Courtesy of HYUNDAI MOTOR AMERICA
Remove the lever plate (A) and lever packing (B).

Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the planet gear (A).

Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the planet shaft assembly (A) and lever (B).

Courtesy of HYUNDAI MOTOR AMERICA
Press the stop ring (A) using a socket (B).

Courtesy of HYUNDAI MOTOR AMERICA
Remove the stopper (A) using the stopper pliers (B).

Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the stop ring (A), overrunning clutch (B), internal gear (C) and planet shaft (D).

Courtesy of HYUNDAI MOTOR AMERICA
To reassemble, reverse the order of disassembly.
NOTE:
- Using a suitable pulling tool (A), pull the overrunning clutch stop ring (B) over the stopper (C).
Courtesy of HYUNDAI MOTOR AMERICA