LEMON Manuals: Even more car manuals for everyone
Home >> Genesis >> 2018 >> G80 3.8 Ultimate, AWD >> Repair and Diagnosis >> Brakes >> Traction Control >> Electronic Stability Control Diagnosis >> DTC C1513: Brake Switch Circuit Error >> DTC Information >> DTC Detecting Condition

DTC Information: DTC Detecting Condition

Item Detecting Condition Possible Cause
DTC Strategy
  • Circuit monitoring
  1. Open or short circuit in brake switch line
  2. Faulty brake light switch
  3. Faulty Stop Signal Electronic Module
Enable Conditions
  • Outside an ABS/ESP (ESC) control, If the Pressure Sensor Signal is higher than 15bar and BLS is OFF for 1 sec, The failure is detected when the case occurs 3 times in same ignition cycle
  • While Reference Vehicle Speed> 20km/h (12 mph), Master Cylinder Pressure < 7bar, if Brake Light Switch is ON longer than 2min. The failure is detected when the case occurs 3 times in same ignition cycle
Fail-Safe
  • Inhibit the ESP (ESC)/DBC/AVH control and allow the ABS/EBD control
  • The ESP (ESC)/DBC/AVH warning lamp is activated
scientia non olet · About LEMON Manuals