Repair Procedures: Replacement

CAUTION:

NOTE:

When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
When removing the interior trim pieces, use a plastic panel removal tool not to damage the surface.
Take care not to bend or scratch the trim and panels.

Using a screwdriver or remover, remove the knob upper cover (A).

Courtesy of HYUNDAI MOTOR AMERICA
Using a screwdriver or remover, remove the console upper cover (A).

Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the main connector (A).

Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the shift lever connectors (A).

Courtesy of HYUNDAI MOTOR AMERICA
After loosening the mounting screws and bolts, remove the shift lever (A).

Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the console connectors (A).

Courtesy of HYUNDAI MOTOR AMERICA
Using a screwdriver or remover, remove the console side cover (A).
[LH]

Courtesy of HYUNDAI MOTOR AMERICA

[RH]

Courtesy of HYUNDAI MOTOR AMERICA
Remove the console armrest tray (A).

Courtesy of HYUNDAI MOTOR AMERICA
Remove the console armrest service cover (A).

Courtesy of HYUNDAI MOTOR AMERICA
Loosen the console armrest mounting bolts.

Courtesy of HYUNDAI MOTOR AMERICA
After loosening the mounting bolts, remove the floor console assembly (A).

Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the multimedia jcak connectors (A).

Courtesy of HYUNDAI MOTOR AMERICA
To install, reverse the removal procedure.
Information
- Make sure the connector is connected properly.
- Replace any damage clips.